Recycled Parts Moderator Newsgroup, Discussion Board and Trading Place > Curbside Centers
> Plastic
> Containers
> Heck trace-a-punch model 3C manual duplcator metal fab
Heck trace-a-punch model 3C manual duplcator metal fab
Below are details from the Heck website:
model3ca.gif (11626 bytes) model4a.gif (10075 bytes) misca.jpg (12810 bytes)
This is the easiest, most economical way to produce low production metal and plastic profiles. Trace-A-Punch® follows your guided template to produce burr free straight and contoured outlines and holes. Simple, rugged meehanite casting construction insures very little maintenance.
An existing part can be used as the master pattern or one can easily be made by tracing over acetate-plastic .020-1/2" with a sharp scriber or razor knife. An office copier can be used to produce a master by copying on to Mylar-plastic and cutting with scissors.
